Question: Windmill problem

    I'm running 1.15 smp and I've set up a wind mill on the top of one of my building so its elevated a bit. What I was curious about was if that I needed to add something to the windmill to make it run. I currently have it configured with a wire coming out of the bottom supporting it 3 spaces above any blocks. No EU is running down the wire at all. I've tested it on numerous occasions because i know it can vary from 0-3. Is there a specific setup to get the windmill to run correctly?




    Thanks,
    GC

    Greetings.


    As far as I can tell, you should get windmill running after you set it up and have some device it stores produced energy. This applies to all power generators.


    Basically problem can be that windmill works better higher it is located so it is putting out some sub 1 eu/t. You can see if it is producing any by looking at the energy capacitor units like :MFE-Transmitter: or :MFS-Unit:


    If still not working, then you got some weird problem there.