the planner simply assumes that you replace the RSH when it melts, or that you feed it with redstone somehow
Oh, ok thanks, i didn't know that...
the planner simply assumes that you replace the RSH when it melts, or that you feed it with redstone somehow
Oh, ok thanks, i didn't know that...
Then why does Reactor planner says it can last Full cycle? I must be wrong in something?
That wasn't Gregtech, and you should only need a couple redstones to fresh up that red module, so that you can use it again.
Also in planner, it says FULL CYCYLE, no meltdown, why do you think it will meltdown?
Am i wrong in somewhere?
18 uranium cells are used in this layout, for 250 eu and 2.78 efficiency,
this is a little bit low, you can get nearly the same amount of energy with only 8 uranium ores, which is crafted as quad cells. Also you can gain an efficieny like 6.
For example http://i45.tinypic.com/2qmm8gn.png
Or you can craft 2 reactors with 4 chambers for each one and can use Ricks' Mark 1 EA* layout, which is located at the first page.
- Link: Mark I-SUC EA
- Eu/tick: 520
- Efficiency: 4,33
- Cost: Copper 1746, Tin 169, Bronze 3, Iron 346, Gold 42, Glass 114, Uranium 24, Rubber 534, Redstone 283, Glowstone 2, Lapis Lazuli 29, Diamonds 19
- Running costs: 169,52 UU
- Credits: Informatixa
This kind of cooling needs continuous maintenance with redstone or lapislazuli, so efficiency goes down a little bit in practise, you should use something like coolant cell so that it can cool itself down, not with your help.
I mean that's what i thought, but good output though...
Here is my youtube videos for Mark 1 EA* 140 EU reactor.
Basically this design gives you the highest efficiency, also you can see an autoloader system for neutron reflectors and fuel rods,which is also sustaining the generation of power more than 13 hours, and finally a message screen that gives you warning when reactor is out of fuel, or reloading fuel, over heated, closed because overheated, closed because mfsu is full, .
I'm thinking about a video that explains the logic circuits that i 'have used in this system.
Edit note: This mark1 EA* system is more expensive than the one in the first post ,stated in the best designs section, only advantage of this system is the ability of refilling itself and control mechanisms.
http://www.youtube.com/watch?v=e7S_GZlZXFM
http://www.youtube.com/watch?v=DjT_LvdOXbg