Is this bug?
Scanner is not accepting the IV Piston and Data Stick. It worked for the motor and pump but not the piston. I tried this for the new scanner, new piston and new data stick.
Also, in this setup, when I remove the data stick from the scanner, it disappears.
Railcraft anchors are know to do it just right so it does not cause part of the multi-block to load or unload in a breaking manner. You'd prefer admin anchors to be safe though, and always avoid crossing chunk boundaries to be totally safe. Do not try this with Chickenchunk or FTBMod.
Thank you! I was about to it with the Chickenchunk! I'm relocating the base and hole IV setup could go for poof MinecraftChicken!
Question: If everything is chunk loaded, can I build the GT multiblock stuffs over the chunk boundary?
Did you tried out to connect the pipe on eah side? From what I have seehn there is only on the back smth. what can be called output. Try this out on the back and report then; would not wondering if some GT-Machines are only giving stuff
out on the back but this must I check too.
Hope that I could help you with this :).
None of the side works.
My replicators, IV, EV or HV are not being connected any pipes. Tried to pump it directly from the mass fab but it did not work. I even added the pump covers to all the possible sides but the pipes did not attached. GT pipes and other fluid transportation methods did not attached nor worked on the replicators. Any help would be appreciated.
