Hi
Oh - the picture is a simulation
the reactor was built etirely new - all componentes unused - then i put some new std. vents and exchangers in - all the same..
using single rods would take some time to get the componets really hot so it would be possible to genrate some energy untill a cooldown would be required... but there mus be something wrong as i see theese componets used in oter designes.. and ..there must be at least one type of heat distributing component inside the reactor - if non of the avaliable componets were designed for use in fluid reactor no safe configuration would be possible..
The target is to build a liquid reactor as safe as my EU Reactor... the shown design runs at 120 EU/t with 2% Heat forever in EU mode..
But again - how to set up a safe design if all available heat managing reactor componets prompt that they ar not for use in liquid reactor..
i m surpised as i expected rather to experience troubles in getting the heat processed properly as this is new to me and i miss slots for liquid ecetor upgrades to fix the output direction.. the issue in the reacto itself is a bit murphy style..
must be something i miss