World Control monitors not updating, as well as other wonky stuff?

    So I placed the panel like this:

    MMMMM

    MMXMM


    where M is a monitor, and X is the extender. I powered it via a lever attached to the extender in the back, and found that even when my reactor was on, it didnt update the display unless I cliked into the reactor GUI. The remote monitor works fine, though.


    Also, I have also noticed that when I place a reactor location card into the top left slot of the monitor, then save, quit and exit MC, the next time I load in, the location card gets replaced by a time sensor card.. What's wrong? Is it my setup or a bug?


    I have IC2 industrialcraft-2-2.8.109-ex112.jar, and World Control WorldControl-1.0.18.jar