I was reading the wiki and it says that water blocks in a 3x3x3 area around the reactor contribute to cooling..does this mean within 3x3x3 of any chamber? Or just the central reactor block? Also, I was curious as to how many layers of reinforced stone is sufficient to contain a meltdown? Thanks!
Question about water surrounding a reactor?
-
Only 3x3x3 area around central reactor block. Chambers don't increase the area.
-
Make a obsidian wall around the reactor its more resistant to explosion. Unless you use a ton of uranium it wont break.
-
obsidian was nerfed in IC2. now it is weaker than reinforced stone. you need three layer of reinforced stone to completly contain full reactor explosion.
-
obsidian was nerfed in IC2. now it is weaker than reinforced stone. you need three layer of reinforced stone to completly contain full reactor explosion.
source?
-
I have tasted and about 5 layers should stop the melt down
-
source?
ablaka himself http://forum.industrial-craft.…read&postID=3883#post3883 obsidian have 60 and reinfced stone have 100. stone have 30.
-
obsidian was nerfed in IC2. now it is weaker than reinforced stone. you need three layer of reinforced stone to completly contain full reactor explosion.
I use obsidian 2 blocks thick and nuclear explosion doesnt go through it only when the obsidian melts (but hey 1 hole in it wont do much damage..). Another thing i noticed is that the reinforced stone behind the hole did break thus obsidian>reinforced stone. Prolly got changed back i guess.
-
Are you Saying that Obsidian Needs to Layers Instead of One. And that It is now Breakable?
If So that's a Bit Worrying.
And Another thing. To patch up the hole where the wire and redstone etc come out you just turn the wire in another direction immediately then you have a Obsidian Block 1 Block away from the hole. So if there is a Meltdown/Explosion then it Would still be contained.
This is what I mean.
http://imgur.com/ucBIq -
