So, I've been experimenting with the new electricity system, and noticed a glitch when using the EU-Reader. I'm not exactly sure what caused it..... Screenshots below in spoiler.
EU Reader giving negative readings?
-
i have the same problem, but its very rare.
its only happend two times after i removed a cable and quickly clicked on a cable next to the removed cable -
- Official Post
It doesn't support changes to the wiring during the measurement.
-
It doesn't support changes to the wiring during the measurement.
Maybe it should print a message in that case, instead of just garbage values.
-
EU\t reading at cables seems to be "short" (-32k ... + 32k) or "char" (-65k ... + 65k) value .
When you first right-click a cable, you start measurement. When you right-click second time, you get a number of EU's transmitted through that cable since last right-click.
For I.E. You measure 200 EU transmitted in 180 ticks (9 seconds?), you'll get "-3233" result.
So, "reading" excels "short (32k) or "char" (65k) and goes negative, as it was in SMP GUI's at IC1.
