A flow of 25 is far too high. If you could actually supply that much heat to it, you'd be getting 2 and a half buckets of steam a tick. The base amount is a pressure of 0, and a flow of 1, which takes 100 HU/t to give 100 mb/t of Steam. At 220 Bars and a flow of 1, it takes 200 HU/t to give 100 mb/t of Superheated Steam. Each flow increase is adding onto this again, so a flow of 3 at 0 bars will give 300 mb/t of Steam for 300 HU/t.
Now it start working, thanks a lot!
i give almost 200Hu/t, it happen even if set pressure at 50 bars, and flow about 25. But when i set preassure for 200 bars, wait for tempeture about 630K, then drop the pressure to 100 bars, for few sec i have steam and all works but heat input drops to 0 and tempeture going down quickly, when drops to saturation temperature, heat input come back and generator start doing the same thing i've sad earlier.
I make some screens:
http://przeklej.org/file/w3sQFV/2015-05-22.10.24.21.png
http://przeklej.org/file/pz0Bmu/2015-05-22.10.24.12.png
http://przeklej.org/file/bR5uW2/2015-05-22.10.24.15.png
http://przeklej.org/file/BImfzn/2015-05-22.10.23.50.png
http://przeklej.org/file/BKDunm/2015-05-22.10.23.53.png
http://przeklej.org/file/BPhriF/2015-05-22.10.23.54.png
http://przeklej.org/file/rqln13/2015-05-22.10.23.55.png
http://przeklej.org/file/QLCbga/2015-05-22.10.23.59.png
http://przeklej.org/file/bWwdYS/2015-05-22.10.24.02.png
http://przeklej.org/file/XClWBc/2015-05-22.10.24.05.png
http://przeklej.org/file/UxlWwL/2015-05-22.10.24.07.png
http://przeklej.org/file/k0AnNe/2015-05-22.10.24.10.png
guys i have some problem with steam generator, it seems to disconect from heat source (reactor fluid port) when start generate steam, when steam amount go into turbine, start heat again, have you encounter that problem? accidentaly doubled posts, sorry for mess
Guys I have some problems with steam generator, it seems that once start produce steam disconnect from heat source for blink, when whole steam gone in turbine, it start heat again, did you encouter that issiue?
