{1.64][BUG][SSP] Electrolyser

BillJoehobo · February 11, 2012 at 3:10 PM

The electrolyser dosn't charge water cells.

Alblaka · February 11, 2012 at 4:28 PM Official Post

Thanks for the extremely well-detailed error report, we'll look into the error-log/description you provided and fix the nailed-down issue.

\obvious sarcasm.

Would you mind elaborating how you used the Electrolyser where in which manner? I'm quite sure it's not being used correct.

BillJoehobo · February 11, 2012 at 4:49 PM

After putting water cells in the Elctrolyser and hooking up a MFE the cells did not charge. I didn't have an error report, the cells just wouldn't charge.

Talonius · February 11, 2012 at 9:23 PM

I'll assume when you said you 'hook up' the electrolyzer you tried to place a cable between the two. To use the Electrolyzer you need place it immediately next to one of the MFE's input sides. Once the MFE is about 90-95% full, it'll start charging the water cells, It will also pull EU back out of the cells if the MFE's power reserves are low.

BillJoehobo · February 11, 2012 at 10:53 PM

No i didn't use a cable, but i was putting it on the output side so that may have been the problem...

Ya, that was it.

Thanks

Alblaka · February 12, 2012 at 7:54 PM Official Post

Quote from billjoehobo

No i didn't use a cable, but i was putting it on the output side so that may have been the problem...

Ya, that was it.

Thanks

Nope, that wasn't it. Electrolyser does not care for enet, it just accesses adjacent MFEs.
However, most likely your MFE did now reach 70% energy level. Electrolysers will not draw power if a storage block is below the 70% mark.

Users Viewing This Thread