Support Request: Windmills not making power [But there is wind]

I've had some windmills [Set up like a solar tree] set up for a couple days with no issues. Today I swapped out my batbox for an MFE for powering advanced machines. Everything worked fine for awhile.

Now, they produce no power. If I reset cables, they will start producing around 5eu/t total for a few minutes, and then drop to 0 permanently again. Any ideas?

Set up is basically this:

=Air
=Batbox
=Windmill
=MFE
=Tin Cable
=Glass Fibre Cable

ETCETCETC

ETCETCETC

Ugh, wrote a full message and then pressed reset. Reset should not exist, and if it does.. should be on the left. Submit is always on the right in other forums.

Anyway, it works again. Must have been a really unlikely scenario with no wind for awhile.

Thanks for heads up on the seperate IC/IC2 forums!