Support Request: Windmills not making power [But there is wind]

1st Official Post

    I've had some windmills [Set up like a solar tree] set up for a couple days with no issues. Today I swapped out my batbox for an MFE for powering advanced machines. Everything worked fine for awhile.


    Now, they produce no power. If I reset cables, they will start producing around 5eu/t total for a few minutes, and then drop to 0 permanently again. Any ideas?


    Set up is basically this:


    :Advanced Machine: =Air
    :Batbox: =Batbox
    :Wind Mill: =Windmill
    :MFS-Unit: =MFE
    :Dynamite: =Tin Cable
    :Sticky Dynamite: =Glass Fibre Cable


    :Advanced Machine: :Wind Mill: :Advanced Machine:
    :Wind Mill: :Dynamite: :Wind Mill:
    :Advanced Machine: :Dynamite: :Advanced Machine:
    :Advanced Machine: :Dynamite: :Advanced Machine:
    ETCETCETC
    :Advanced Machine: :Batbox: :Advanced Machine:
    :Advanced Machine: :Sticky Dynamite: :Advanced Machine:
    :Advanced Machine: :Sticky Dynamite: :Advanced Machine:


    ETCETCETC
    :Advanced Machine: :MFS-Unit: :Advanced Machine:

    • Official Post

    Sure that there is Wind?, because Wind is a variable and there can be a small period of no Wind.


    You posted in the wrong Supportsection.


    @Admins, Why is M4d, MeC archived, while IC1 is not? That causes confusion.

    Ugh, wrote a full message and then pressed reset. Reset should not exist, and if it does.. should be on the left. Submit is always on the right in other forums.


    Anyway, it works again. Must have been a really unlikely scenario with no wind for awhile.


    Thanks for heads up on the seperate IC/IC2 forums!