Hello Everyone!
I'd like to start off by saying i've been lurking around here for a bout a week, and only been playing tekkit for about 2. I have been heavily addicted to tekkit ever since i read about nuclear reactors and got all excited :).
Last night i brought Lucy, the Mark I-O-SUC reactor online. I should point out i built her all by hand, no creative. The feeling that it just..works..is great.
Link to reactor design: http://www.talonfiremage.pwp.b…m5sggiryvohdt5chdfg0zwn40
Reactor Stats:
130 EU/t
2.60 Efficiency
SUC: 1 ice per 4 seconds (Lucy is heat Neutral at that rate)
Surrounded by 23 water blocks.
Cooling system(Turns On and Off with the reactor)
6 IC2 Pumps
6 Compressors with 1 overclock each
1 Compressor with 5 overclocks
Transposers to extract snowballs and deliver ice to the reactor
(i realize i could have just used EMC for the ice but where's the fun in that?)
Cooling Power: Self-contained Solar powered. Total draw is about 40 EU/T
7 LV solar arrays connected to two MFE's with LV transformers attached. The MFE's power the cooling system quite easily overnight, and recharge during the day.
I also have 3 Remote thermal monitors hooked up. They have their own seperate power supply (2 LV Arrays, attached to a MFE with LV transformer)
Fault logic:
*No ice within 4 seconds
*Thermal Monitors have no power
*Heat reaches 8400
*Any signal sent to my black wire
Thanks for reading. Here are some screenshots for your viewing pleasure:
Some Cooling Logic(top of cooling block):
Picture of facility. Reactor on the left, COntrol room front, cooling system back
Inside Lower part of cooling block
Control Room: