Does This work? (Various Cooling Tower designs)

Okay, I was working on a crazy idea for a CRCS cooling tower, using quad-uranium cells to simulate a nearly empty cell to show heat distribution.

Instead, I get this. Which supposedly works. Even though it shouldn't.

As the observant of you have likely already noticed, this is a modular design, with a cell in the middle of a square with gold fans in the corners, component heat exchangers above and below, and component heat vents on the sides. Then copypasta this six times.

It shouldn't be cooling 96 H/s according to my calculations, however. Each of the heat exchangers should be pulling in 36 H/s, and the component vents each cooling 4/s. In other words, it should only be cooling 80 H/s, not 96. Where is the other 16 cooling per tic coming from? Have I beaten the C00ld0wn's record, or is there a glitch in the system somewhere?

It's a fairly sub-par stand-alone as is. The efficiency sucks, it's an absolute gold hog, and there are other reactors which produce more EU/t. However I don't see why it makes it to the full cycle in the first place.

I think I found a cooling tower which cools 144/t, however it only has room for two cells in a six-chamber cooling tower. Build found here, using Quad-Plutonium to demonstrate the cooling capacity.

Yes, the central gold vent is shared, however it's a marginally used vent anyways, as you can vent all available heat able to be pulled by the gold component heat exchanger with seven gold vents and simply be shy by four heat.

Due to how cooling cells transfer heat (or rather, how they don't), 144/s is the theoretical cap of cooling per second per cell, as it is the fastest you can pull heat out of them (at 36/s from the component heat exchangers, and having one on each of the four sides).

here is another design I've worked on, however I don't know if it works as well as I think it does.

Optimally, it should be cooling 112/s from the three component heat transfers and one component heat vent. It's got enough vents to vent that much heat. And it would be able to be stacked so you get six of them in a six chamber larger version. Or just stack individual two-chamber two-cell ones. Whichever you prefer.

Quote from Kenken244

I don't see how you would able to stack six coolant cells in a six chamber version without reducing the amount of cooling for each cell. the most I can get is four.

Hmm... point made. Yea, you can only get four, but 112 Cooling/second is still pretty boss.

Quote from Kenken244

depends. the real metric for cooling tower effectiveness is amount of cooling for the cost. It doesn't matter if you need 6 or 8 cooling towers, just how much it costs to build all of them.

Needing six rather than eight towers is almost certainly going to be cheaper...

Compare/contrast with the C00ld0wn towers at 95 Cooling/tic with approximately the same cost.