Compact Mox CRCS System

Simply put, it is a 2x6x2 (11 block) combination of 3 cooling reactors with one chamber each, a power-generating reactor, an MFSU for 'internal' storage and usage monitoring, an ME Interface (Applied Energistics) for extracting fresh fuel from a local storage system while depositing spent fuel, a computer terminal (ComputerCraft and OpenPeripherals) that manages the whole system and a single HV cable needed to reach the MFSU.

Generator Reactor
Generator Reactor (Neutron Reflector Version)
Cooling Reactors (Design by Someone Else 37 i believe)

Program Code

[size=12]Mods Required: ComputerCraft 1.58+, OpenModsLib 0.2+, OpenPeripheral Core 0.3.1+, IC2 2.0.354E+, Applied Energistics 2 RV0.14+

The first step is to put down the bottom layer. This includes a reactor in the middle-front for generating power, two reactors on the left-front and left-back that will become cooling reactors, a reactor on the middle-back with a chamber placed at right-back to make up the first complete cooling reactor and finally a HV cable at front-right.

Step 2 is to put down the top layer comprising of 2 reactor chambers on left-front and left-back to complete the final 2 cooling towers, the computer terminal at front-middle, an MFSU on front-right (doesn't matter where the output faces, though you could fit in an EV-Transformer behind at right-back if needed) and an ME Interface behind the computer at middle-back (no setup required, just place it and wire it up to your ME system).

Step 3 just involves filling each of the reactors to the designs in the top spoiler section.

Step 4 is to right-click the computer to start and access it and run 'pastebin get faiMaJLn startup' to download the program and name it startup so it is auto-loaded each time the computer boots.

The final step is to reboot the computer (hold Ctrl+R for a few seconds), enter the compass direction it asks for (needed so that OpenPeripherals knows which direction to move cells etc around) and then entering 'start' once the program is setup to start the reactor.

Commands Available

• Start - Starts a stopped reactor
• Stop - Stops a running reactor
• Exit - Cools the reactor to 0 and exits the program
• Reboot - Reboots the computer