[HELP] Solar Panels bugged?

Kenny85246 · Oct 3rd 2011

Hello, i have been using a small 5 solar flower to power my bat box, it has been working fine but suddenly it shows no output when reading with the EU meter.
I am running v1.00 on SSP.

There are only 3 cables total between the solar flower and the bat box so i dont think EU decay is the issue
Even if i remove the solar panels and place them somewhere else it still reads 0 EU.

Any help is appreciated

Direwolf20 · Oct 3rd 2011

Is the bat box full? Energy won't travel through a wire if it has nowhere to go.

Ranakastrasz · Oct 3rd 2011

Also make sure they are receiving light, as in daytime, and it has nothing above it blocking sunlight (glass is fine)

Kenny85246 · Oct 3rd 2011

Quote from Direwolf20

Is the bat box full? Energy won't travel through a wire if it has nowhere to go.

That might be the problem i think the bat box was full when i measured and it is daytime when i tested this

EDIT: I just tested this and that was the problem, The solar panels need to have something to feed power too to even send power. This makes sense. Thanks guys

xKillerbees · Oct 3rd 2011

I'd update your IC2 as well.

Direwolf20 · Oct 3rd 2011

Quote from Kenny85246

That might be the problem i think the bat box was full when i measured and it is daytime when i tested this

EDIT: I just tested this and that was the problem, The solar panels need to have something to feed power too to even send power. This makes sense. Thanks guys

Glad to help

Share