"Stable" design isn't stable in Age of Engineering modpack

Hello,

I am using the following reactor setup which has been listed as stable.

030C0D140D0D0C0D15150C0D0D0C0D0D030D150D030D0D030D0D0C0C0D0D0C0D0D0C0D150D030D0D030D0D030D150D0C150D0C150D0C

According to the IC2 Experimental Reactor Planner it is stable. However in Age of Engineering (IC2 version 2.2.26.234-ex110) I have a component that degrades to 0. It is the Overclocked Heat Vent in the top row, fourth slot from the right. I degrades and when gone causes the reactor to fail.

Does anyone have any insight as to how I could make this plan stable?

I also tried automating replacement of the vent using EnderIO conduits with an Advanced Filter. However setting the filter to >25% damage doesn't seem to register. I can set the filter to use exact NBT data and it replaces fine, but I can't quite grab all of the damage levels necessary to assure getting the weakened component out for repair.

Any thoughts or insights are greatly appreciated.

Thanks.

Quote from Aroma1997

Does it happen on the first cycle or did you automate the reactor and it happened sometime later?

It happens right away. I assumed it was stable so I powered it up, watched the MFE it was filling, then looked back in it about 3-4 minutes later and saw components were gone. After making some more I ran it again watching the whole time and that one component deteriorates to 0. I believe the one to the left does as well, but it takes much longer to get there.

Sure. Here you go.

Since I had done an upgrade copy for the server I decided to wipe the directory and refresh it. After that it worked in my test world correctly so I should be able to get it working in my real world again.

Thanks for the help. I really appreciate it.

No so far it has run for several cycles without an issue. Thanks!