IC2 beginner guide request.

  • I just f'cked up some of my low level 32 volt machines using a MFE, in the guide it says nothing about using transformers.
    This should be changed ASAP, as its a pain in the ass not knowing why your macerater, canning machine and extracter blowing up.

  • I just f'cked up some of my low level 32 volt machines using a MFE, in the guide it says nothing about using transformers.
    This should be changed ASAP, as its a pain in the ass not knowing why your macerater, canning machine and extracter blowing up.

    If you read the wiki, it will tell you which machines accept LV, MV and HV.
    You can use transformers to change the voltage, ex. MV to LV, or reverse. however there is another way for you to use MV or HV in your machines - but is up to you to find it on the wiki :P


    on the wiki, there actually is a small "first steps tutorial" http://wiki.industrial-craft.n…itle=Tutorial:First_Steps


    and don't worry, you are not the first to blow up something by accident with the wrong voltage.