The Title says everything, Splitter cable only use "Standart" Redstone dust, with torch, not even a normal torch neither Redpower Wiring.
Hope that gets Fixed in next patch's 
[1.103/1.97] Splitter Cable Redstone Behavor.
-
Did you try to connect the redstone wire DIRECTLY to the cable? Since it seems like that behavior is the same for all IC2 machines when connecting to RP2 wiring.
-
You need to power the Cable with First-Degree-Redstone in order for it to work. But Redpowers Wires can only do Second-Degree-Redstone, unless they sit directly on the Targetblock, what is only possible with full Blocks. So try to use a Buffergate the next time.
-
Eloraam is not respecting redstone connectivity as she should be
-
Eloraam is not respecting redstone connectivity as she should be
Uhhm nope, you dont respect the Vanillaredstone as you should do.
You use "worldObj.isBlockGettingPowered"
Everyone else including me uses "worldObj.isBlockIndirectlyGettingPowered"
-
Indirect checking would cause it to check through blocks, which may be inconvenient if you have detector and splitter cables close to each other.
-
Indirect checking would cause it to check through blocks, which may be inconvenient if you have detector and splitter cables close to each other.
Is it more inconvenient, than having to put repeaters for wiring it? I doubt it is, because seriously, who is going to put those right next to a Detectorcable?
-
Indirect checking would cause it to check through blocks, which may be inconvenient if you have detector and splitter cables close to each other.
In that case, I'll put up with it until a better solution is found.
