stirling kinetic generator

gereid · Apr 12th 2016

Hello, i was looking information about this device, but i could not find anything over whole internet.

What i found is that it can accept water, and outputs hot water, and in process it generates some kinetic energy, now the question is: how to extract/insert fluids at best rate, as EXU transfer nodes are clearly bottleneck, what are extra slots inside machine used for?

Chocohead · Apr 12th 2016

It accepts heat and a cold fluid, which is in turn converted into kinetic power and a hot fluid. The 2 slots on the left and right are for cells for the tanks, while the 3 in the middle are for upgrades.

VirMan · Sep 3rd 2017

it does not accept cold coolant

Aroma1997 · Sep 3rd 2017

As coolant, it only accepts fluids, that cannot be coolead down again. Otherwise, ou could get into a infinite cycle byo heating up fluids and cooling them down again.

VirMan · Sep 3rd 2017

well.. what is the point then... what it is used for ?

Chocohead · Sep 4th 2017

The point is to turn heat into kinetic energy, the produced hot fluid is very much a by-product rather than the main output.

Share