Title says it all. I plan on building an extremely energy-demanding power line soon with as efficient reactors at possible (i.e. EA*) with high output. Therefore, I plan on building microcycle reactors. However, I am not a very good reactor designer, so would anybody mind making one for me? It can be very expensive, but cost-efficiecy would help too.
Has anybody made a Microcycle Reactor yet?
-
-
not sure if this is what you want, butthis may be suitable? It's only eff A, so it might be on the low side. It is the design I use on my survival map, might not be the best but it is quite nice. I let it run for 2m30s, cooldown is 5, about 1.1m EU is produced during run. no running cost, and a redpower pipe system can maintain it.
Cheers!
-
I edited your Setup. http://www.talonfiremage.pwp.b…m0l189lxael8cll38ln10jg1s
Has almost the same running/cooldown time. So 100sec. clock + togglelatch = Profit?
-
yep, this is better, changed to it. Thanks
-
I saw this thread, came up with a few designs, and then forgot to post them here . Anyway, here they are:
Active Eu/T: 410
Average Eu/T: 227.777
Timing: 5 seconds on, 4 seconds offActive Eu/T: 420
Average Eu/T: 233.333
Timing: 5 seconds on, 4 seconds offActive Eu/T: 560
Average Eu/T: 248.888
Timing: 4 seconds on, 5 seconds offThey cool down fast but can't run very long. They're best used with a timer.
-
EU/t: 720
Timing: 5/8
Effective EU/t: 300
Efficiency: 6 of 6
Running Cost: 187.2 UU
Profit: 211.6 EU/t
Overall Efficiency: 4.58EU/t: 600
Timing: 5/4
Effective EU/t: 333.3
Efficiency: 5 of 5
Running Cost: 72 UU
Profit: 297 EU/t
Overall Efficiency: 4.46Both would requive HV wiring, and both have a couple of extra slots for plating... for safety.