last time i checked chest against TNT they blow up.
Posts by nou_spiro
-
-
So i read this topic http://forum.industrial-craft.…page=Thread&threadID=2066 and i want make new contest. Highest EU/t and highest average EU/t within Mark-II category that mean no meltdown. Don't post any CASUC reactors. (Mark-I can also apply).
So my own design:
Mark-II-1 ED
90EU/t
average: 56EU/t
http://www.talonfiremage.pwp.b…ii=1k10101001511621s1r11r -
well that can be pretty dangerous if you wait to spawn a lava. lava can also destroy redstone which shutdown the reactor. i still think that my system is better as it trigger sooner only when it begins spawn fire.
-
I need to ad a emergency shutdown system to my reactor so it wont blow up if a nab decides to turn the cooling off.
try this http://forum.industrial-craft.…page=Thread&threadID=1907
-
yes it should work. but don't forget that if block catch on fire is random. in my system it detect all bottom blocks.
-
what about include this http://forum.industrial-craft.…?page=Thread&postID=11954 emergency shutdown mechanism?
-
-
source?
ablaka himself http://forum.industrial-craft.…read&postID=3883#post3883 obsidian have 60 and reinfced stone have 100. stone have 30.
-
obsidian was nerfed in IC2. now it is weaker than reinforced stone. you need three layer of reinforced stone to completly contain full reactor explosion.
-
i think this http://forum.industrial-craft.…page=Thread&threadID=1907 is better than any reinforced stone chambers.
-
you should make two spots for cool down elements. AFAIK HD dispensers can suck only 6 heat per tick. so four HD can suck up 24 heat per tick but whole reactor can cool down more so it only waste have full reactor of cooling cells. i think to fully utilize this you need three spots for heated elements.
-
yea. 9 nukes are much more powerfull than full reactor.
-
wait for 1.9. then you can make snowman which generate snow. after that you can easily harvest snow.
-
of course it is little slow. it won't stop reactor which go from 50% to 85% in few seconds. but rougly it stop reactor in 10-20 seconds. so it should be capable stop even Mark-IV reactors. if reactors overheat after 1000 seconds it hits 50% at 588 second mark. so it have over 400 seconds to stop before meltdown.
-
three layer of reinforced stone. obsidia was nerfed so it is weaker than reinforced stone.
-
connect it via cable. you can connect cable to any chamber which is attached to reactor.
-
I got idea how to stop overheated reactor. Basic idea is that overheated reactor begin to spawn fire on flamable blocks. So it destroy wooden block. this way it can make hole in bottom of reactor chamber so water began to leak. This water destroy redstone torch which interupt signal to NOT gate which send dignal into reactor so it stop. More in image:
-
you can connect it to any chamber. so you can have full 3x3x3 water cooling.
-
-
or use very high voltage. even on 100 block long distance it loss 4% of energy.
