I am setting up my very first Wind farm in IC2, however first I wanted to test sending power down the the wire to the base of my tower. I hooked a regular generator to the top and no power is being transmitted. I Used a EU meter and everything is coming up 0's. The system (for debugging right now, I will remove the single segment wires when I figure out my problem) is
:Generator: -> :Cable: -> :LV-Transformer: (redstone applied) -> :Cable: -> :HV-Transformer: (MV, redstone applied) -> 53x :Cable: -> :HV-Transformer: (MV) -> :Cable: -> :LV-Transformer: -> :Cable: (insulated copper) -> :Batbox:
All wires uninsulated HV unless noted. The HV's in the diagram are MV, the forum does not have a icon for a MV transformer.
The two transformers on the top have redstone torches attached, and power is coming in on the 1 dot side and coming out the 3 dot side.
The tow transformers on the bottom have no redstone and power is coming in on the 3 dot side and going out the 1 dot side.
The bat box has power coming in the no dot side and nothing attached to the output and is empty.
I get no power transferred to my batbox at the base of the tower. If I attach a bat box to the top before the first transformer it will start to fill fine.
What mistake am I making on my wiring setup?
EDIT: Changed title from MV to HV as the main link is a HV connection