So I'm using a pump (standalone, not attached to a miner) to suck up water to supply an ore washing plant. I've got the water set out in the usual 1x3 config for an infinite supply, with the pump sitting above the middle block. The thing is, the pump seems to randomly select one of the two 'ends' of the 1x3 strip thus breaking the whole setup.
Is this expected behavior? I seem to remember the pump only doing 1 block directly below it before, but I admit that it's been a while, so I could be remembering incorrectly.
Minecraft 1.12.2 / IC2 2.8.113 from the Enigmatica 2: Expert modpack