You should really look around a bit before posting any designs. Yours is very inefficient and expensive. Better design can be put together in a minute actually.
A list of good reactor designs (IC² v1.103 and earlier)
-
-
You should really look around a bit before posting any designs. Yours is very inefficient and expensive. Better design can be put together in a minute actually.
I put that reactor together within 3 days from when I made a new world, and the reactor never overheats so it never melts down, also, it generates 120EU/t. I did remove the post, I only posted it for feedback on it. Also, it was my first design i made from scratch.
-
I put that reactor together within 3 days from when I made a new world, and the reactor never overheats so it never melts down, also, it generates 120EU/t. I did remove the post, I only posted it for feedback on it. Also, it was my first design i made from scratch.
Well, that was feedback. Before posting more designs, it is good to see at least fisrt page of this thread to compare you creations. If you need feedback or help, it is better to create a new topic.
-
Well, that was feedback. Before posting more designs, it is good to see at least fisrt page of this thread to compare you creations. If you need feedback or help, it is better to create a new topic.
I know it was feedback and i wasn't trying to sound angry. I am sorry if I did sound angry, but i didn't mean to. I also did see the first page and I tried to post something that gave of a relatively high EU compared to safety. At the time of posting, i didn't remember exactly how much the components had cost. -
"Too much" is fitting.
-
-
"Too much" is fitting.
Ok, lets say Too Much, or perhaps, Destroyed your minecraft world finding these resources? -
http://www.talonfiremage.pwp.b…6cspi29xa3m0njahnb82m9gsg
Took me 30 secs to make this one cheaper with same specs.
-
Mark II-6
Output: 120 EU/t
Effective: 106.9 EU/t
Total EU: 24,000,000
Efficiency: 1.50 out of 1.50
Excess Heating: 6.6
Cooldown: 20 minutes, 24 seconds
Maximum Cycles: 6.77Hope you like it. Highest EU/t in the Mark II section as far as I know.
= 
-
Display More
Mark II-6
Output: 120 EU/t
Effective: 106.9 EU/t
Total EU: 24,000,000
Efficiency: 1.50 out of 1.50
Excess Heating: 6.6
Cooldown: 20 minutes, 24 seconds
Maximum Cycles: 6.77Hope you like it. Highest EU/t in the Mark II section as far as I know.
= Can you see the post above yours ? also this quick one
-
Made this quick Mark III reactor in a few minutes.
http://www.talonfiremage.pwp.b…ew1215djn65nqcrmbd4qyg3k0 -
Made this quick Mark III reactor in a few minutes.
http://www.talonfiremage.pwp.b…ew1215djn65nqcrmbd4qyg3k0And why do you post this here?
Seriously ppl if you reactor sucks just dont even bother flooding this topic with them.
If you need help making a good reactor look at the designs in the list, read the instructions and if that doesnt help you then you may make a topic. But pls dont post anymore totally useless designs in this topic. This topic is supposed to have good designs in them not 1st time tries from newbies. Everyday i check this topic only to see there 3 new post with really bad designs in them. Most of the time simply reading the first post would have been enough to prevent this.
Hope i was clear. -
This is my Beating Heart
And i made this in 3Min!!!! THIS IS NOT SHITTY!!!!!
But im sorry about cooling time, Heh i hope you guys dont move your reactor every 145Mins :DD -
This is my Beating Heart
And i made this in 3Min!!!! THIS IS SHITTY!!!!!
But im sorry about cooling time, Heh i hope you guys dont move your reactor every 145Mins :DDIt IS bad. In fact very, very bad. I designed something way better in about 30 seconds. This produces as much energy with a way higher efficiency, has much lower building costs, has a lower cooldown time and the average output it way better. Better in any possible way, and it still isn't good. Please refer to Rick's earlier post.
-
This is my Beating Heart
And i made this in 3Min!!!! THIS IS NOT SHITTY!!!!!
But im sorry about cooling time, Heh i hope you guys dont move your reactor every 145Mins :DDYou sir failed at reading the post above yours....
Lets just ignore any reactors that arent worth it. Too much post are being made because a bad design was posted..
-
Thanks to the post by Rick (Master Engineer) I had my first reactor up and running in 3 days about 32 hours of IC2 play time. Why don't you ppl just listen to him and STOP Trying to reinvent the WHEEL!!!
-
How to hell i Cool Reactor 40Million Eu ,Active Eu 200?
-
If you guys can make better Reactor in 30sec, Then make Reactor same specs as this in 30sec http://www.talonfiremage.pwp.b…ukmye5wbk6gbtej3hrfls4pq8
-
If you guys can make better Reactor in 30sec, Then make Reactor same specs as this in 30sec http://www.talonfiremage.pwp.b…ukmye5wbk6gbtej3hrfls4pq8
YOU FAILED AGAIN, EVEN I KNOW THAT!!! You are not allowed to add Waterbuckets or Iceblocks into the Scheme, read the RULES BEFORE POSTING.
Quote from Rick-No SUC/CASUC designs (this means NO ICE OR BUCKETS!!). Having free spots for optional ice/bucket cooling is allowed through.
-
rick why do you still let people post here? can't you have it rigged so your the only one who can post in this thread?
